Furnace Blowing Cold Air Repair in Mount Prospect
Furnace blowing cold air in Mount Prospect? Learn common causes like tripped limit switches and flame sensors, or call for fast local repair.
What Furnace Blowing Cold Air Involves
Diagnosing cold air from supply registers requires checking thermostat fan settings, inspecting the air filter and return ducts, reading the control board LED fault code, and testing flame-rectification microamps. Return to our Mount Prospect furnace repair homepage anytime to view all heating services.
Common Signs You Need Service
- Cool air blowing continuously even though the thermostat is set to Heat
- Air starts warm for 2 minutes, then turns cool while the fan keeps running
- Thermostat display shows 'Heat On' but outdoor exhaust pipe feels cold
- Airflow feels weak at basement or second-floor supply registers
Diagnostic & Repair Process
Before calling, verify your thermostat fan is on AUTO and replace a visibly clogged filter. If cold air persists, a technician inspects the limit switch, flame sensor, gas valve, and condensate trap. Depending on what the technician finds, this service often pairs with gas furnace repair or igniter and pilot repair.
Cost Factors in Mount Prospect
Flame sensor cleaning or replacement is among the most affordable furnace repairs, whereas control board or gas valve replacement costs more.
Neighborhoods Served
Local technicians dispatch daily to Downtown & Metra District, Prospect Meadows, and every block in ZIP code 60056. See all neighborhoods on our Service Areas Hub.
Frequently Asked Questions
You can safely check that the thermostat fan is set to AUTO, replace a dirty air filter, and verify the circuit breaker is on. Beyond that, call a technician.
A brief 30-to-60-second cool draft is normal while ductwork clears, but prolonged cold air indicates burner ignition failure or an overheating lockout.